Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) VOLTAGE REGULATOR/RECTIFIER Voltage Regulator Continuity Test Due to internal circuitry, there is no static test available to check continuity. NOTE: Initial current reading will be higher than specified due to the battery drain from the engine start. This proves the charging system works. Current load will come down as the battery re- covers its charge. If current is below specification, carry out a stator output test and wiring harness prior to concluding that rectifier is faulty.
Voltage Regulator/Rectifier Replacement Voltage Regulator/Rectifier Removal Remove components to reach voltage regula- tor/rectifier as described in BATTERY REMOVAL of this subsection. Disconnect connectors from voltage regula- tor/rectifier. Lift and push the top of electrical component sup- port forward to unlock it from the battery holder. PROCEDURES CHARGING SYSTEM FUSE The charging system is protected by a 30 A fuse (F15). If the battery becomes discharged, check the charging system fuse condition, located in fuse box #2. Remove fuse box cover. Refer to POWER DISTRI- BUTION. ssi2009-002-008_a 1.
Electrical component support Lift electrical component support to reach the bot- tom locking tab of voltage regulator/rectifier. Unlock the bottom locking tab of voltage regula- tor/rectifier and pull out voltage regulator/rectifier. 2009-027-009_a 1. Fuse box #1 2. Fuse box #2 The voltage regulator/rectifier could be the culprit of a blown charging system fuse. To test for this possibility, simply disconnect the voltage regula- tor/rectifier from the circuit and install a new fuse. If the fuse still burns, check for a shorted wire or connector pins. NOTICE Do not use a fuse of a higher rating as this can cause severe electrical system and component damage. smr2009-033-006_a Step 1:
Push and hold Step 2: Pull out 300 smr2009-033 OUTPUT CURRENT TEST TEST ENGINE SPEED CURRENT (DC) 5500 RPM Approx. 10 A (while suspension does not move)