Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) Use the vacuum/pressure pump in the ENGINE LEAK TEST KIT (P/N 295 500 352) . Set vacuum/pressure pump to VACUUM. Set vacuum/pressure pump to PRESSURE. 295500352 smr2009-031-013_a 1. Vacuum selected Squeeze the vacuum/pressure pump handle sev- eral times to draw air in through the check valve. Check valve must hold air with 10 in Hg (-34 kPa) of vacuum without leaking. smr2009-031-012_a 1. Pressure selected Connect vacuum/pressure pump to the vent hose end. Squeeze the vacuum/pressure pump handle sev- eral times to push air out through the check valve. Check valve must let air flow out.
smr2009-033-010_b MUST HOLD AIR IN THIS POSITION If any test failed, check the vent hose and if good, replace check valve. At installation, ensure to position check valve with black side connected to vent line and ORANGE side inserted in the grommet protruding through the hull as shown. smr2009-033-010_a AIR MUST FLOW OUT 302 smr2009-033