Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) 6. Remove the electrical component support from the battery holder. 6.1 Lift and push the top of electrical compo- nent support forward to unlock it from bat- tery holder. smr2009-033-009_a 1. Disconnect here 9. Install a piece of hose (same type as vent hose) with a cap or small hose pincher onto the bat- tery vent to prevent electrolyte spillage when removing the battery. 10. Remove battery with battery holder from ve- hicle. ssi2009-002-008_a 1. Electrical component support 6.2 Pull up the components support to unhook from battery holder and move it aside to make room for removing battery. 7.
Remove and discard both screws securing bat- tery holder to battery holder base. CAUTION Be careful not to disconnect the hose from the battery vent and cause an elec- trolyte spill in the watercraft. ssi2009-002-009_a 1. Retaining screws 2. Battery holder 8. Disconnect the vent hose from battery. smr2009-033-008_a 1. Vent plugged for removal WARNING Electrolyte is poisonous and corrosive. Avoid contact with eyes, skin and clothing. Wear a suitable pair of non-absorbent gloves when removing the battery by hand. Rinse any affected area with clear running water for at least 15 minutes, then seek professional medical attention. 304 smr2009-033