Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) NOTICE Should any electrolyte spillage oc- cur, immediately wash off area with a solution of baking soda and water, then rinse thor- oughly. Remove retaining screws from battery holder if applicable. smr2009-005-006 Remove battery holder from battery. smr2009-005-004_a 1. Remove screws Unlock the upper tabs then slightly open battery holder. smr2009-005-007 Battery Cleaning Clean the battery casing, caps, cables and battery posts using a solution of baking soda and water. NOTICE Do not allow cleaning solution to en- ter battery. Remove corrosion from battery cable terminals and battery posts using a firm wire brush.
Rinse with clear water then dry well. smr2009-005-005_a 1. Unlock here Battery Inspection Visually inspect battery casing for cracks or other possible damages. If casing is damaged or shows signs of acid leaking, replace battery and thoroughly clean battery tray and surrounding area with a solution of water and baking soda. Inspect battery posts for corrosion and security of mounting. Inspect for cracked or damaged battery caps, re- place defective caps. NOTE: Hand tighten caps then tighten an ad- ditional 1/4 turn using a 20 mm (3/4 in) socket. Using any other tool could damage the plastic battery caps. Separate lower tabs to unlock them. smr2009-033 305