Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) WARNING Battery electrolyte is caustic. To prevent spillage, ensure battery cell caps are suffi- ciently tight to properly seal each cell. Battery Voltage Test (No Load) NOTE: Be aware that the voltage test can indi- cate that the battery is in good condition even though the battery does not have enough stored energy to crank the engine. A load test gives a more accurate indication of the condition of the battery. If the battery has just received a charge, allow it to rest for 1-2 hours before taking a voltage reading. Set multimeter to Vdc and measure voltage at bat- tery terminals.

Battery Electrolyte Level Check electrolyte level in each cell, add distilled water up to the upper fill level line. NOTICE Add only distilled water in an acti- vated battery. Battery Testing There are 3 types of battery tests. FULLY CHARGED BATTERY VOLTAGE (NO LOAD) 12.6 Vdc minimum Battery Electrolyte Reading NOTE: Do not top up cell electrolyte level with distilled water prior to taking an electrolyte read- ing. Check charge condition of each cell using a hy- drometer. NOTE: A hydrometer measures the charge of a battery in terms of specific gravity of the elec- trolyte.

Battery Voltage Test (Load Applied) Use a load testing device such as the ELECTRO SPECIALTIES BATTERY LOAD TESTER (P/N 710) . It has a 500 A carbon pile adjustable load. Follow battery load tester instructions. Apply a load of 3 times the ampere-hour rating of the battery for 14 seconds, then check battery voltage. ' 1. Hydrometer If battery voltage has dropped below specifica- tion, the battery storage capacity has decreased appreciably and the battery should be replaced. Most hydrometers give a true reading at 21°C (70°F). In order to obtain the correct value, adjust the ini- tial reading by adding or substracting the number indicated in the following table.

306 smr2009-033 TEST METHOD COMMENT Voltage test (load applied) A dynamic voltage test with a load applied gives an accurate indication of the condition of the battery. This is the most recommended method. Voltage test (no load) A static voltage test is carried out without discharging current. It is the simplest and most commonly used but the most likely to give false results. Battery electrolyte reading Gives an accurate indication of the charge condition of each cell. BATTERY ELECTROLYTE SPECIFICATION BATTERY CONDITION SPECIFIC GRAVITY Fully charged 1.265 - 1.280 BATTERY VOLTAGE TEST (LOAD APPLIED) TIME TO MEASURE INTO TEST VOLTAGE 14 seconds 10.5 Vdc min.