Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) The battery must always be stored fully charged. If required, recharge until the recommended spe- cific gravity obtained prior to storage. NOTICE Battery electrolyte temperature must not exceed 50°C (122°F) during charging. The battery casing should not feel hot to the touch. Clean battery terminals and cable connections us- ing a wire brush. Apply a light coat of dielectric grease on terminals. Clean battery casing and caps using a solution of baking soda and water. EXAMPLE NO. 1 EXAMPLE NO. 2 NOTICE Do not allow cleaning solution to en- ter battery. TEMPERATURE ABOVE 21°C (70°F): Hydrometer reading: 1.250 Electrolyte temperature:

- 1°C (30°F) Subtract .016 Corrected: 1.234 TEMPERATURE ABOVE 21°C (70°F): Hydrometer reading: 1.235 Electrolyte temperature: 38°C (100°F) Add .012 Corrected: 1.247 Rinse battery with clear water and dry well using a clean cloth. Store battery in a cool dry place. Such conditions reduce self-discharging and keep fluid evaporation to a minimum. Keep battery away from dew, high moisture and direct sunlight. During the storage period, recheck electrolyte level and specific gravity readings at least every month. If necessary, top up the electrolyte level with distilled water, then recharge (trickle charge). Recharge frequency depends on battery condi- tion and storage temperature.

Maintain battery as per following table. Battery Storage Disconnect and remove battery from watercraft as explained in BATTERY REMOVAL. WARNING Batteries must always be stored out of reach of children. NOTICE Battery storage is critical for battery life. Regularly charging the battery during storage will prevent cell sulfation. Keeping the battery in vehicle for storage may lead to con- tacts degradation/corrosion and case damage if freezing occurs. A discharged battery will freeze and crack in areas where freezing condi- tions are experienced. Electrolyte leakage will damage surrounding parts.

Always remove battery from vehicle for storage and regularly recharge it to keep an optimal condition. Activation of a New Battery WARNING Never charge or boost battery while installed in watercraft. Perform the following operations anytime a new battery is to be installed. Remove the sealing tube from the vent fitting. Check electrolyte level in each cell. Add distilled water up to upper level line as nec- essary. NOTICE Do not overfill. smr2009-033 307 ELECTROLYTE TEMPERATURE OPERATION TO PERFORM °C °F 38 32 27 100 90 80 Add to the reading: .012 .008 .004 21 70 CORRECT READING 16 10 4 - 1 60 50 40 30 Subtract from the reading:

.004 .008 .012 .016 STATE OF CHARGE AS PER HYDROMETER READING (CORRECTED) STATE OF CHARGE SPECIFIC GRAVITY @ 27°C (80°F) @ 4°C (40°F) 100% 1.26 - 1.27 1.27 - 1.28 75% 1.21 - 1.22 1.22 - 1.23 50% 1.16 - 1.17 1.17 - 1.18 25% 1.12 - 1.13 1.13 - 1.14 0% 1.10 or less 1.11 or less AMBIENT TEMPERATURE CHARGING FREQUENCY Below 16°C (60°F) Every month Above 16°C (60°F) Every 2 weeks