Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) NOTE: Some chargers have a polarity protec- tion feature which prevents charging unless the charger leads are connected to the correct battery terminals. A completely discharged battery may not have enough voltage to activate this circuitry, even though the leads are connected properly. This will make it appear that the battery will not accept a charge. Follow the charger manufac- turer's instruction on how to bypass or override this circuitry so that the charger will turn on and charge a low-voltage battery. 3.

Since battery chargers vary in the amount of voltage and current they provide, the time re- quired for the battery to accept a measurable charger current may be up to 10 hours or more. 4. If the charging current is not up to a measurable amount after 10 hours, the battery should be replaced. 5. If the charging current is measurable before the end of the 10 hour period, the battery is good and charging should be completed at a lower rate as specified in ACTIVATION OF A NEW BATTERY. 6. It is recommended that any battery recharged using this procedure be tested under load prior to returning it to service. 5. Remove the temporary hose used to plug the battery vent. 6.

Reconnect the watercraft vent hose to the bat- tery vent outlet. Make sure vent hose is not pinched or bent. WARNING Vent hose must be free and open. Avoid skin contact with electrolyte. smr2009-033-009_a 1. Connect here 7. Attach the electrical component support to the battery holder. Battery Installation 1. Install battery in its holder and lock holder. 2. Secure battery holder with its retaining screws if they were present at removal. ssi2009-002-008_a 1. Electrical component support WARNING Always connect battery cables in the spec- ified order, RED positive cable first, BLACK negative cable last. smr2009-005-004_a 1. Torque to 6 N•m (53 lbf• in ) 8. Connect RED (+) cable. 9.

Connect BLACK (-) cable last. 3. Install the battery in the watercraft using new screws. 4. Tighten battery holder screws to 14 N•m (124 lbf• in ). 310 smr2009-033