Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) For best results, battery should be charged when it is at room temperature. A battery that is cold may not accept current for several hours after charging has begun. Do not charge a frozen battery . If the battery charge is very low, the battery may freeze. If you suspect the battery to be frozen, move it to a heated area for about 2 hours (or more if required) to let it thaw out before charging. ) * Step 1: Disconnect battery charger from AC outlet Step 2: Disconnect - lead Step 3: Disconnect + lead WARNING Always charge a battery in a well ventilated area. 6. Test battery state of charge. Use a hydrometer.
The time required to charge a battery will vary de- pending on several factors, such as: Battery temperature: The charging time is in- creased for a cold battery as charging current accepted by a cold battery will be lower than for a warm battery. As the battery warms up, it will accept a higher rate of charge. State of charge: As a battery discharges, it gives up its stored energy. The greater the dis- charge, the longer it will take to fully recharge it. Type of charger: Battery chargers vary in the amount of voltage and current that they can supply. 1. Hydrometer ' 7. If electrolyte level has dropped after charging, fill with distilled water to UPPER LEVEL line.
After water is added, continue charging for 1 to 2 hours to mix water with electrolyte. 8. Reinstall caps and clean any electrolyte spillage using a solution of baking soda and water. NOTE: Hand tighten caps then tighten an ad- ditional 1/4 turn using a 20 mm (3/4 in) socket. Using an other tool could damage the plastic battery caps. Charging a Very Flat or Completely Discharged Battery The battery charger used should have an ad- justable charging rate. A unit which can be adjusted in small increments is acceptable. The battery charger must be equipped with an am- meter capable of accurately measuring current of less than 1 ampere.
Unless this procedure is properly followed, a good battery may be needlessly replaced. 1. Measure the voltage at the battery posts with an accurate voltmeter. If it is below 10 volts, the battery will accept current at very low rate. It could be some time before the charging rate increases. Such low current flow may not be detectable on some charger ammeters and the battery will not seem to accept the charge. 2. Exceptionally for this particular case, set the charger to a high rate. WARNING Battery electrolyte is caustic. To prevent spillage, battery cell cap should be suffi- ciently tight to properly seal. Charging a Used Battery WARNING Never charge battery while installed in water- craft.
smr2009-033 309