Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 05 (STARTING SYSTEM) STARTING SYSTEM SERVICE TOOLS Description Part Number Page DIAGNOSTIC HARNESS ............................................................... 529 036 179 ......................................... 315 ECM ADAPTER TOOL................................................................... 529 036 166 ................................. 317–319 FLUKE 115 MULTIMETER ............................................................ 529 035 868 ................................. 315–318 SERVICE PRODUCTS Description Part Number Page DIELECTRIC GREASE ...................................................................

293 550 004 ......................................... 324 ISOFLEX GREASE TOPAS NB 52 ................................................. 293 550 021 ......................................... 323 LOCTITE 243 (BLUE)..................................................................... 293 800 060 ......................................... 323 GENERAL Starting system failures are not necessarily re- lated to the starter but may be due to one the following: Starter solenoid fuse F4 Battery. Refer to CHARGING SYSTEM START/STOP switch Starter solenoid D.E.S.S. post ECM Wiring/connections. Check these components before removing the starter. NOTE:

This section assumes the problem is re- lated to an electrical component of the starting system. If starting system tests good, ensure en- gine and jet pump integrity. Refer to applicable section. BASIC STARTING SYSTEM OPERATION Engine Cranking Conditions The following conditions must be met to allow en- gine cranking: The D.E.S.S. key must be on its post and rec- ognized by the ECM as valid (2 short beeps) START/STOP button pressed and held. Starting System Logic If the ECM recognizes a valid D.E.S.S. key, it al- lows engine cranking by providing the ground to the starter solenoid when the START/STOP but- ton is pressed and held.

If the START/STOP button is activated while the throttle lever is depressed more than 60%, the en- gine will crank but will not start (engine drowned mode). If the START/STOP button is held after engine has started, the ECM automatically stops the starter if engine speed reached at least 1400 RPM. If the START/STOP button is pressed when en- gine is running, the engine will be shut down. DIAGNOSTIC GUIDELINES The following is provided to help in diagnosing the probable source of troubles. It is a guideline and it should not be assumed to list all possible prob- lems. ENGINE DOES NOT CRANK TROUBLESHOOTING 1. D.E.S.S. operation non functional or wrong D.E.S.S.

key - If 2 short beeps are not heard when pressing the START/STOP button, refer to DIGITALLY EN- CODED SECURITY SYSTEM. DIAGNOSTIC TIPS NOTE: It is a good practice to check for fault codes using B.U.D.S. software as a first trou- bleshooting step. Refer to MONITORING SYS- TEM/FAULT CODES section. 2. Burnt fuse: battery, starting system - Check wiring then replace fuse. smr2009-034 313