Section 05 ELECTRICAL SYSTEM Subsection 05 (STARTING SYSTEM) 3. Discharged battery - Check/recharge. Refer to CHARGING SYSTEM. STARTER TURNS, BUT STARTER DRIVE DOES NOT MESH WITH RING GEAR 4. Defective START/STOP switch - Check. 1. Worn starter drive gear - Replace starter drive. Refer to PTO HOUSING AND MAGNETO. 5. Battery connections - Check/clean/tighten. 2. Defective drive - Replace starter drive. Refer to PTO HOUSING AND MAGNETO. 6. Poor/bad or corroded ground contacts (engine, starter etc.) - Check/clean/repair. 3. Poor movement of drive on splines - Clean and correct. Refer to PTO HOUSING AND MAGNETO. 7. Starter solenoid - Check. 8. Starter malfunction - Check. 4.
Worn starter drive bushing - Replace clutch. Refer to PTO HOUSING AND MAGNETO. 9. Obstructed starter drive gear assembly - Check/repair, refer to PTO HOUSING AND MAG- NETO. 5. Worn ring gear - Replace ring gear. Refer to PTO HOUSING AND MAGNETO. ENGINE CRANKS SLOWLY STARTER KEEPS RUNNING 1. Loose battery cables - Check/clean/tighten. 1. Shorted solenoid winding - Replace solenoid. 2. Discharged/weak battery - Check/charge/replace. Refer to CHARGING SYS- TEM. 2. Melted solenoid contacts - Replace solenoid. 3. Sticking or defective starter drive - Lubricate or replace. Refer to PTO HOUSING AND MAGNETO. 3. Worn starter - Check, refer to STARTING SYSTEM. STARTER DOES NOT TURN PROCEDURES 1.
2 short beeps are not heard when pressing the START/STOP button - Refer to DIGITALLY ENCODED SECURITY SYS- TEM. WARNING When carrying out any kind of maintenance on the starting system, always disconnect the battery ground cable. This will eliminate the possibility of shorting out a power cable, and generating a spark which could result in a fire or and explosion. Do not place tools on the battery. 2. Burnt fuse - Check wiring condition and replace fuse. 3. Poor contact of battery terminal(s) - Clean and tighten terminal(s). 4. Poor battery ground cable connection - Clean and tighten. STARTER SOLENOID FUSE 5. Weak battery - Recharge or replace battery.
Check starter solenoid fuse (F4) condition in fuse box 1. If it is burnt, it can be quickly identified by the following symptoms: The information center will come on and turn off after 5 seconds. A fault code will be set. Engine will not crank when pressing the START/STOP button. 6. Poor contact of START/STOP switch or solenoid - Check connectors and clean contacts. Check and replace defective parts. 7. Open circuit: START/STOP switch or solenoid - Check. Replace if necessary. 314 smr2009-034