Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 05 (STARTING SYSTEM) NOTE: The solenoid may be the cause of a burnt fuse (F4). If fuse is good, proceed with the STARTER QUICK TEST. Measure resistance through switch as per follow- ing table. ENGINE START/STOP SWITCH Start/Stop Switch Operation Test Open the front storage cover and remove the stor- age bin. Lift suspension using the iS up button. NOTE: If more height is required or if the iS can- not be used, manually lift suspension by the an- chor points close to handlebar and safely block in this position. NOTICE Stop lifting as soon as suspension has fully extended. Disconnect the 8-pin connector below the moving deck in the steering area.

smr2009-030-033_d If switch does not test as specified, replace the engine START/STOP switch. If switch tests as specified, perform the START/STOP SWITCH INPUT VOLTAGE TEST. Start/Stop Switch Input Voltage Test Keep the same test setup as for the START/STOP SWITCH OPERATION TEST. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select Vdc. Measure voltage as per following table. smr2009-042-005_b 1. 8-pin connector here Connect the DIAGNOSTIC HARNESS (P/N 529 036 179) to make an in-line connection between the disconnected connector. NOTE: Plug only the connector that has been dis- connected. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select .

529036179 smr2009-034 315 START/STOP SWITCH OPERATION TEST SWITCH POSITION 8-PIN CONNECTOR OF DIAGNOSTIC HARNESS RESISTANCE Released Pins 1 and 2 Infinite (OL) Pressed and held Close to 0