Section 01 MAINTENANCE Subsection 04 (SPECIAL PROCEDURES) SPECIAL PROCEDURES SERVICE TOOLS Description Part Number Page LARGE HOSE PINCHER................................................................ 529 032 500 ........................................... 12 SUCTION PUMP ........................................................................... 529 035 880 ........................................... 12 GENERAL WATER-FLOODED ENGINE Refer to the following special procedures accord- ing to the specific event. If engine is water-flooded, it must be serviced within a few hours after the event. Otherwise engine will have to be overhauled.
PROCEDURES NOTICE Never try to crank or start the engine. Water trapped in the intake manifold would enter the combustion chamber through the intake valves and may cause damage to the engine. A water-flooded engine must be properly drained, lubricant replaced (oil change), op- erated (boil out procedure), then lubricant replaced again, otherwise parts will be seri- ously damaged. TOWING THE WATERCRAFT IN WATER Special precautions should be taken when towing a Sea-Doo watercraft in water. Maximum recommended towing speed is 24 km/h (15 MPH).
This will prevent the exhaust system from filling with water, which may lead to water being in- jected into and filling the exhaust system and the engine. Without the engine running there is not any exhaust pressure to push the water out the exhaust outlet. Whenever the engine is stopped, all the valves close thus preventing water from being ingested in the engine. NOTICE Failure to do this may result in dam- age to the engine. If you must tow a stranded watercraft in water be sure to stay well be- low the maximum towing speed of 24 km/h (15 MPH). Exhaust System Draining If water is suspected to be in the exhaust system, remove the exhaust pipe and the muffler.
Drain them or siphon the water out of them. Refer to EXHAUST SYSTEM subsection. Intake System Draining If water is suspected in the intake manifold, re- move the intake manifold and drain it. Then suck out the water from the intake valve ports. Refer to INTAKE MANIFOLD subsection. If water is present in the air intake silencer, empty it. Remove air intake silencer and check for water in the supercharger inlet hose. Remove hose to empty it. Remove the water from blow-by valve hose. SUBMERGED WATERCRAFT Drain bilge. If it was submerged in salt water, spray bilge and all components with fresh water using a garden hose to stop the salt corroding effect.
Engine Lubrication Refer to WATER-FLOODED ENGINE in this sub- section. Fuel Inspection Check fuel tank for water contamination. If nec- essary, siphon and refill with fresh fuel. Throttle Body Lubrication Throttle body should be lubricated to prevent cor- rosion. smr2009-015 11