Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 01 MAINTENANCE Subsection 04 (SPECIAL PROCEDURES) Supercharger Servicing If there was water in the oil or in the supercharger inlet hose, it is recommended to take the super- charger apart, dry all the components, replace the slip clutch needle bearings and shaft ball bearings. Refer to SUPERCHARGER section. 8. Put a tape at 400 mm (16 in) from the end of the suction pump tube. 9. Insert the tube in the PTO area until the tape reach the cylinder-block edge. Then, siphon contaminated oil out. Engine Oil and Filter Replacement If water gets in the oil (oil will be milky), change the engine oil and filter as per procedure further in this subsection. Remove the deck extension.

Refer to BODY sub- section. 1. Using the SUCTION PUMP (P/N 529 035 880) , siphon the contaminated oil from the engine reservoir through dipstick hole. smr2006-006-003_a TYPICAL 1. Suction pump tube with tape 2. Edge of cylinder-block 10. Remove the suction pump tube. 11. Reinstall valve cover. 12. Install a NEW oil filter and reinstall the oil filter cap. 13. Fill up the reservoir with fresh oil. 14. Proceed with the boil out procedure: NOTE: The boil out procedure is intended to evap- orate the water contained in the oil. NOTICE Never crank or start engine when siphon tube is in dipstick hole. Never start engine when there is no oil in engine.

5290358802 Boil Out Procedure in a Test Tank or Tied to a Trailer with Watercraft in Water 1. Connect the vehicle to B.U.D.S. to monitor the coolant temperature. It must exceed 100°C (212°F) in order for the water boil out. Once the boil point is reached, it won't take long to evaporate the water. 2. Run the engine for 5 minutes at 3500 RPM. 2. Remove the suction pump tube from the dip- stick hole. 3. Fully depress throttle lever and HOLD it for cranking. 4. Crank the engine for 5 seconds. 5. Remove the oil filter cap and the oil filter. Refer to LUBRICATION SYSTEM subsection. 6. Again, siphon the contaminated oil from the oil filter reservoir. 7. Remove valve cover.

Refer to CYLINDER HEAD subsection. WARNING Make sure to safely secure the watercraft. 3. With the engine still running at 3500 RPM, in- stall a LARGE HOSE PINCHER (P/N 529 032 500) to the coolant line going to the oil cooler. smr2006-006-001_a 1. Valve cover 12 smr2009-015