Section 01 MAINTENANCE Subsection 04 (SPECIAL PROCEDURES) 5290325002 WARNING Certain components in the engine compart- ment may be very hot. Direct contact may re- sult in skin burn. Do not touch any electrical parts or jet pump area when engine is run- ning. smr2009-015-001_a 1. Oil cooler coolant inlet hose 4. Continue to run the engine at 3500 RPM for 15 more minutes (20 minutes total run time). 5. Shut the engine off. 6. Remove the hose pincher on the coolant line going to the oil cooler. NOTICE Hose pincher must be removed prior to operating the watercraft. Failure to do this will result in damage to the engine. 7. Change the oil and filter again. 8. Procedure is now completed.
CAPSIZED WATERCRAFT Capsized for More Than 5 Minutes Refer to WATER-FLOODED ENGINE in this sub- section. smr2009-015 13