Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 05 (STARTING SYSTEM) NOTE: It may be necessary to pull retaining tab to ensure proper locking. Wiggle solenoid to ensure it is securely locked. Reinstall remaining components. Reconnect battery and test starter solenoid oper- ation. BLACK booster cable: Connect one clip to the negative (-) battery termi- nal in the vehicle . Momentarily apply the second clip to the negative (-) terminal of the external battery. STARTER Starter Quick Test To easily bypass the starter solenoid and the start control circuits, proceed as follows. Use a fully charged 12 V battery with a capacity of at least 30 A-h.

Use an external battery to prevent connection sparks in hull. Use a set of booster cables to power the starter. This procedure tests the following: electric starter starter power cable battery to engine ground cable. smr2009-034-011_a Step 1: Connect cable to solenoid starter post Step 2: Connect cable to vehicle battery positive post Step 3: Connect cable to external battery negative post Step 4: Make a momentary contact WARNING Fuel, oil, or electrolyte vapors are flammable and may become explosive if certain con- ditions are met. These vapors may collect near the bottom of the hull when present.

All types of ignition including electrical sparks are to be avoided when maintaining or test- ing vehicle. If engine does not crank (or slowly cranks), check the following: Booster cable connections Vehicle battery ground cable connections to en- gine Starter power cable/connections from solenoid to starter. If the above items all test good, replace the starter. WARNING Always use an external battery for this test. Always connect the BLACK booster cable clip last to the external battery negative (-) termi- nal. Do not short starter solenoid contacts across the main power connections on the relay with a tool which would cause a spark.

Failure to follow this procedure may result in an explosion. Starter Removal Open seat. Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Remove deck extension. Refer to BODY . Lower moving deck. Remove air intake silencer. Refer to AIR INTAKE SYSTEM. Disconnect battery. Refer to CHARGING SYS- TEM section. WARNING Always wear safety glasses when working with or around batteries. Connect booster cables in this strict order: RED booster cable: Connect one clip to the starter post on the starter solenoid. Connect the other clip to the positive (+) terminal on the external battery. WARNING Always disconnect the BLACK (-) battery ca- ble first and reconnect last. NOTE:

To have a better access starter, work from the RH side of vehicle and lay across the moving deck. 322 smr2009-034