Section 05 ELECTRICAL SYSTEM Subsection 05 (STARTING SYSTEM) Disconnect starter power cable. Remove starter retaining screws. Starter Gear Installation Installation is the reverse of removal procedure. However, pay particular attention to the following. Use a new circlip. Starter Installation Installation is the reverse of the removal proce- dure. However, pay particular attention to the fol- lowing. Ensure starter and engine mating surfaces are free of debris. Serious problems may arise if starter is not properly aligned. Apply ISOFLEX GREASE TOPAS NB 52 (P/N 293 550 021) on starter O-rings. smr2007-025-008_a TYPICAL REAR OF WATERCRAFT IN ON RH SIDE OF ILLUSTRATION 1. Exhaust manifold 2.
Starter 3. Starter retaining screws 4. Starter power cable retaining nut Starter Gear Removal Remove starter. Remove gear retaining circlip and pull out starter gear. smr2007-025-009_a 1. Apply Isoflex grease Topas NB 52 Install starter. NOTE: If starter does not mesh properly with the intermediate gear: Pull starter out, slightly rotate the starter gear then reinstall the starter. Temporarily removing both O-rings makes it eas- ier to align both gears. Once gears are aligned, remove starter to install O-rings being careful not to rotate starter gear out of position, then reinstall the starter.
Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on re- taining screws and torque to 10 N•m (89 lbf• in ). Connect the RED positive cable to the starter and torque retaining nut to 7 N•m (62 lbf• in ). !& 1. Retaining circlip 2. Starter gear smr2009-034 323