Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) GAUGE SERVICE TOOLS Description Part Number Page FLUKE 115 MULTIMETER ............................................................ 529 035 868 .................................344, 353 SERVICE PRODUCTS Description Part Number Page DIELECTRIC GREASE ................................................................... 293 550 004 .........................333, 350, 354 GENERAL NOTE: For a complete overview of the vehicle electrical system, refer to POWER DISTRIBU- TION. It is highly recommended to disconnect the bat- tery when replacing any electric or electronic com- ponent. 2. Install safety lanyard (D.E.S.S.
key) to activate ECM and Information Center when testing pro- cedures require the device or system to be sup- plied with electrical power. IMPORTANT : When B.U.D.S. is being used, the ECM will stop communicating with B.U.D.S. approximately 3 minutes after the START but- ton was pressed. Therefore, operations with B.U.D.S. will be interrupted. To re-initiate the communication, briefly press the START button. Do not hold the START button to avoid engine starting. WARNING Always disconnect battery exactly in the specified order, BLACK (-) cable first, RED (+) cable last. Always reconnect BLACK (-) cable last. Do not place tools on battery.
Circuit Testing Check the related-circuit fuse condition with a fuse tester or ohmmeter (a visual inspection could lead to a wrong conclusion). TROUBLESHOOTING DIAGNOSTIC TIPS NOTE: It is a good practice to check for fault codes using B.U.D.S. software as a first trou- bleshooting step. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE subsection. IMPORTANT: When troubleshooting an electrical system fault, check battery condition, cables and connections first. Electrical Connection Inspection When replacing an electric or electronic compo- nent, always check electrical connections. Make sure they are tight, make good contact, and are corrosion-free.
Dirty, loose or corroded contacts are poor conductors and are often the source of a system or component malfunction. Pay particular attention to ensure that pins are not bent or pushed out of their connectors. Ensure all wire terminals are properly crimped on wires, and connector housings are properly fas- tened. Check for signs of moisture, corrosion or dullness. Clean pins properly and coat them with DIELEC- TRIC GREASE (P/N 293 550 004) or other appropriate lubricant when reassembling them, except if oth- erwise specified such as for the ECM connectors. Pay attention to ground wires. Electrical System Activation 1. Press the START/STOP button. NOTE:
Pressing the START/STOP button without the D.E.S.S. key installed on it's post will turn on electrical power without starting the engine; the information center will cycle through a self-test function and shut off its display after a few sec- onds. However, the electrical system will stay powered up for approximately three minutes after the START button was depressed. smr2009-036 333