Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) PROCEDURES tion). This self test function allows the driver time to ensure that all indications are functioning properly. It also validates the information centers internal circuits, however, this does not validate proper op- eration of the individual external circuits and sen- sors that provide inputs to the information center. If a system fault is detected by the ECM, the ap- plicable message and/or indicator light will be dis- played, and a beep code may be heard.

If the safety lanyard is not installed, the indications in the information center will shut off a few sec- onds after the self test function, but the electrical system power stays on for approximately 3 min- utes. Installing the D.E.S.S. key on its post will turn the indications back on. NOTE: If the START/STOP button is pressed and held without the D.E.S.S. key installed, the infor- mation center will stay on as long as the START button is held. INFORMATION CENTER Information Center Overview The information center (cluster) is a multifunction gauge that supplies several real time useful infor- mations to the driver.

The information can be displayed in three lan- guages (English, French, or Spanish). Units of measurement can be displayed either in Imperial system or in the metric system. Use B.U.D.S. to change the language and units of measurement settings. The operator can view at a glance several indica- tions such as speed, engine RPM, fuel quantity and engine temperature. The gauge can also be used to navigate through and select several gauge functions, system modes of operation, and to change certain settings and system parame- ters. Indicator lamps advise the operator of selected functions or abnormalities. The gauge itself is an electronic module.

Both the left and right handlebar switches send input sig- nals to the gauge. The gauge interprets the sig- nals from the switches and translates the signals into the appropriate CAN (protocol). The translated information is then sent out of the gauge through the CAN bus to the appropriate module so that it can initiate the specific action commanded. In addition, the gauge receives CAN signals from other modules and is able to translate those sig- nals into the appropriate gauge display. The inputs to the gauge include but are not limited to, the VTS, iS, MODE/SET, UP/DOWN arrows, cruise and fuel level sensor.

The gauge incorporates a GPS (Global Positioning System) that it uses for compass and speedome- ter indications, and to provide speed signals to other systems as required for their operation. The beeper is also incorporated in the information center. Self Test Function When the START/STOP button is pressed mo- mentarily and the vehicle powers up, all LCD segments and indicator lights in the information center will turn ON for 3 seconds (self test func- 334 smr2009-036