Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) 9) Multifunction Display When the watercraft is being operated, the multi- function displays provides and indication of com- pass direction, scrolling messages from the fault monitoring system, or a scrolling DOCK MODE ON message when the function is active. The display also allows for the selection of vari- ous functions which, permit changing the numeri- cal display indication, system modes of operation, settings, and displaying system fault codes used for troubleshooting. WARNING Selecting various numerical displays, sys- tem modes of operation or changing settings should only be carried out with the watercraft stopped.
Selecting these various functions while operating the watercraft at speed is not recommended as it deters your attention from situational awareness and can result in severe injury. DISPLAY MODE FUNCTION smo2009-002-114_p Press the UP or DOWN arrow button to the right of the MODE button until the preferred indication name is visible in the multifunction display. RPM SPEED LAKE TEMPERATURE. DEPTH. NOTE: The DEPTH selection is only available if a depth sounder is installed. To display system fault codes in the multifunction display, refer to the MONITORING SYSTEM AND FAULT CODES subsection.
smo2009-002-114_q smo2009-002-114_o MULTIFUNCTION DISPLAY - COMPASS ILLUSTRATED EXAMPLE - RPM SELECTION Press the SET button to select and save the pre- ferred indication, or wait for the display function to time out. The last indication visible will be au- tomatically saved. The numerical display will then switch to the new indication with a small abbrevi- ation of the indication type to its right: FT or M RPM MPH or Km/h °F or °C. Selecting Functions When operating at speed, the multifunction dis- play normally provides an indication of the com- pass direction and azimuth the watercraft is trav- eling.
To select the various functions available through the multifunction display, press the MODE button repeatedly until the desired function is visible: DISPLAY VTS MODE FAULT CODES 338 smr2009-036