Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) Setting Language and Units of Measurement Connect vehicle to the latest applicable B.U.D.S. software, refer to the COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE subsection. 1. Press the START/STOP button to energize the electrical system. NOTE: You will need to press the START button every three minutes or the electrical system will shut off. 2. Select the Read Data button. 3. Choose the Setting tab at the top of the page. At the bottom LH side of the setting page, select the Cluster tab.
smo2009-002-114_u IBR POSITION - FORWARD ILLUSTRATED (F) 14) Compass A GPS incorporated in the information center pro- vides the indication in the multifunction display. The cardinal points, intermediate cardinal points, as well as the azimuth the watercraft is travelling are displayed in the multifunction display by de- fault when the watercraft is moving. For a compass indication to be displayed, the GPS must first have a good link with the navigation satellites as confirmed by the COMPASS active indicator being on in the digital screen. The wa- tercraft must also be traveling at a speed over 5 km/h (3 MPH). smr2009-036-001_a 1. Read Data 2. Setting tab 3.
Cluster tab In the Cluster Language field, choose the desired unit of language, English , French or Spanish . In the Cluster Units field, choose the desired unit of measurement, Imperial or Metric . smo2009-002-114_v TYPICAL 1. Compass indication 2. Compass active indicator WARNING Use the compass as a guide only. Not to be used for precision navigation purposes. smr2008-028-002_a 1. Cluster Language field 2. Cluster Units field smr2009-036 341