Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) Clearing the Maintenance Reminder Indicators When the watercraft, engine or supercharger is due for maintenance, the maintenance reminder indicator light in the speedometer will come on, and a scrolling MAINTENANCE REQUIRED or SUPERCHARGER MAINTENANCE REQUIRED message will scroll in the digital screen. These maintenance reminders must be cleared using B.U.D.S. 1. Connect vehicle to the latest applicable B.U.D.S. software, refer to the COMMUNI- CATION TOOLS AND B.U.D.S. SOFTWARE subsection. 2. Press the START/STOP button to energize the electrical system. NOTE:

You will need to press the START button every three minutes or the electrical system will shut off. 3. Select the Read Data button. 4. Choose the Vehicle tab at the top of the page. 5. At the bottom RH side of the vehicle page in the Last Service field, choose Reset Ser- vice/”Maint” or Reset Supercharger Mainte- nance button as applicable. NOTE: If the supercharger maintenance was car- ried out before the reminder appeared in the in- formation center, the supercharger maintenance reminder must be reset in order to reset the su- percharger maintenance hour counter and prevent the reminder from appearing prematurely.

Information Center Pin-Out Information Center Troubleshooting Press the START/STOP button and install the D.E.S.S. key on the D.E.S.S. post. NOTE: Information center should come on, cycle through its self test function, and stay on for approximately 3 minutes after which all electrical power will turn off. Briefly press the START/STOP button every 3 minutes to reenergize the electri- cal system. Do not hold the START/STOP button to avoid engine starting. Information Center “Does Not Turn When the information center does not turn ON when the START/STOP button is pressed, the power circuit or ground circuit to the information center is probably open. smr2009-036-011_a TYPICAL 1. Read Data 2.

Vehicle tab 3. Reset Service/”Maint” button 4. Reset Supercharger Maintenance button 342 smr2009-036 INFORMATION CENTER PIN-OUT PIN NO. FUNCTION 1 GPS back-up power 2 CAN HI 3 CAN LOW 4 Spare (Buzzer external GND) 5 Spare (Buzzer external GND) 6 Not used 7 Cruise switch signal Vdc 8 Spare (digital input) 9 Not used 10 Cruise switch ground 11 Gauge GND 12 Gauge input Vdc power 13 VTS switch signal (UP or DOWN) 14 iS switch signal (UP or DOWN) 15 VTS and iS switch common 16 UP or DOWN arrow switch signal 17 MODE and SET switch signal 18 MODE/SET, UP/DOWN arrow switch common 19 Fuel level sensor VDC signal 20 Fuel level sensor GND