Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) Continuity Test of Gauge Power Wire 1. Remove lanyard. 2. Disconnect gauge connector. 5. Set multimeter to setting. 6. Test the information center power wire continu- ity as per following table. NOTICE Pull connector lock out sideways. Do not twist the screwdriver. smr2009-042-002_a 1. Gauge connector 2. Pull out to unlock connector 3. Disconnect 12 pin steering connector. smr2009-036-003_a GAUGE CONNECTOR PIN-OUT smr2009-036-004_a 1. Front ventilation box 2. 12 pin steering connector 4. Remove the gauge fuse in FB1. smr2009-036-005_b 12 PIN STEERING CONNECTOR PIN-OUT (STEERING SIDE) A. Connector alignment keyways smr2009-027-011_e FB1 1.
Remove gauge fuse (F1) smr2009-036 347 CONTINUITY TEST OF GAUGE POWER WIRE GAUGE CONNECTOR STEERING CONNECTOR FUSE BOX 1 READING Pin 12 (Violet) Pin 7 (Violet) - Close to 0 Pin 12 (Violet) - A11 Close to 0 - Pin 7 (Violet) A11 Close to 0