Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) smr2009-027-011_g VOLTAGE TEST AT FUSE CONTACTS smr2009-036-006_a BATTERY VOLTAGE TEST 7. Remove the cover from fuse box 2 (FB2). smr2009-027-011_d TYPICAL - CONTACT COORDINATES (FRONT VIEW FB1) If battery voltage is measured at A12 but not at A11 (with fuse installed), replace the fuse. If no voltage is measured at fuse contact A12, slightly lift one corner of the long bus-bar (12 contacts long). 10. Measure for battery Vdc between the bus-bar and battery ground. 2009-027-009_a 1. Fuse box #1 2. Fuse box #2 8. Press the START/STOP button to energize elec- trical system and install the D.E.S.S. key. 9.

Test for battery voltage between each of the terminals atop the gauge fuse and battery ground as per following table. smr2009-036-007_a VOLTAGE TEST AT LONG BUS-BAR If battery voltage is measured at the long bus-bar, repair or replace the wire jumper C12 to A12 (be- hind fuse box). If no voltage is measured at the long bus-bar, test for voltage at the short bus-bar, refer to the POWER DISTRIBUTION subsection. 346 smr2009-036 VOLTAGE TEST AT FB1 GAUGE FUSE TEST PROBES READING Fuse pin numbers A12 (Violet) Battery (-) post Battery Vdc A11 (Violet)