Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) 4. Carry out an input voltage test at the steering connector (vehicle harness side) as per follow- ing table. E smr2009-036-003_c INPUT VOLTAGE TEST AT GAUGE CONNECTOR (12 TO BATTERY GROUND) If battery voltage is measured as specified in ta- ble, replace the information center. If battery voltage is measured to battery ground but not to pin 11, carry out a CONTINUITY TEST OF GAUGE GROUND WIRE circuit from the gauge connector to the ground bus-bar contact in FB2 as described further in this subsection. 6. If battery voltage is not measured at the gauge connector, carry out an INFORMATION CEN- TER INPUT VOLTAGE TEST (AT STEERING CONNECTOR).
smr2009-036-005_a PIN-OUT - 12 PIN STEERING CONNECTOR A. Connector alignment keys If battery voltage is read atf steering connector (vehicle harness side) as specified in previous ta- ble, but was not measured to pin 11 at the gauge connector (gauge ground wire), repair or replace the black ground wire between the gauge connec- tor and the steering connector. If battery voltage is measured to battery ground but not to pin 6, carry out a CONTINUITY TEST OF GAUGE GROUND WIRE described further in this subsection. If no voltage is measured, carry out the following steps. 5. Open the boarding platform and remove the RH storage bin. 6. Test the battery voltage at the battery terminals.
Information Center Input Voltage Test (at Steering Connector) 1. Open the front storage compartment cover and remove the storage bin. 2. Reach in over top of front ventilation box and disconnect the 12 pin steering connector (C01- 12POS). smr2009-036-004_a 1. Front ventilation box 2. 12 pin steering connector 3. Press the START/STOP switch and install the safety lanyard on the D.E.S.S. post. smr2009-036 345 INFORMATION CENTER INPUT VOLTAGE TEST (STEERING CONNECTOR) INFORMATION CENTER STEERING CONNECTOR VOLTAGE Pin 7 (Violet) Pin 6 (Black) Battery voltage Pin 7 (Violet) Battery ground