Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) NO Speed or Compass Indication If there is no speed or compass indication, look for the GPS indicator icon. If the GPS indicator is off, either the GPS cannot uplink with the satel- lites, or the GPS system in the information center is at fault. If another watercraft nearby displays a good GPS uplink (GPS indicator light on in cluster), replace the information center. NOTE: If the GPS uplink is lost while navigating at speed, the speedometer will provide an esti- mated speed indication based on other parame- ters. The compass indication will not be available until a good satellite uplink is reestablished.
Information Center Input Voltage Test (at Gauge Connector) 1. Remove the gauge support cover, refer to IN- FORMATION CENTER REMOVAL in this sub- section. 2. Disconnect the gauge connector. NOTICE Pull on connector with your hand as you pull the connector lock out with the screw- driver. Do not twist the screwdriver. Speed and Compass Indication Slow to Come ON When initially powering up the watercraft and driv- ing away, the speed and compass indications may be slow to come on. This is normal as the GPS requires time to establish an uplink with the navi- gation satellites (cold start).
If the watercraft was run long enough to display the compass and speed indications, shut down for a short period of time and restarted (hot start), and the speed and compass indications take more than 30 seconds to come on, test for the follow- ing: GPS fuse 23 in FB2 Battery voltage at pin 1 of the information cen- ter Continuity of wire between information center (pin 1) and contact B4 of FB2. NOTE: This circuit provides 12 Vdc to the GPS in the information center so that it memorizes the satellites it was linked to for a period of two hours. This allows the indications to be available within a few seconds of restarting the watercraft (hot start).
After a two hour period, the GPS will have to reestablish new satellite links. smr2009-042-002_a 1. Gauge connector 2. Pull out to unlock connector 3. Set the FLUKE 115 MULTIMETER (P/N 529 035 868) to Vdc. 4. Press the START button and install the safety lanyard on the D.E.S.S. post. 5. Measure the information center input voltage as per following table. Beeper Does Not Function The beeper is incorporated within the information center. If no beep code is heard when installing the D.E.S.S. key, first ensure ECM is powered. Refer to ELECTRONIC FUEL INJECTION subsection.
If the ECM is powered and the ECM and informa- tion center are communicating properly through the CAN bus, replace the information center. E smr2009-036-003_b INPUT VOLTAGE TEST AT GAUGE CONNECTOR (12 TO 11) 344 smr2009-036 INPUT VOLTAGE TEST AT GAUGE CONNECTOR PROBE VOLTAGE Pin 12 (Violet) Pin 11 (Black) Battery voltage Pin 12 (Violet) Battery ground