Section 05 ELECTRICAL SYSTEM Subsection 07 (GAUGE) If voltages measured on every switch are as spec- ified (or very close to it), the switches and the wiring harness are good. The fault may be within the gauge. Replace the gauge and carry out a new MODE/SET AND UP/DOWN TEST USING B.U.D.S. to ensure the problem is solved. 6. Install connector on new switch assembly. 7. Insert switch assembly in switch support. 8. Install steering cover, refer to STEERING AND O.T.A.S. WATER TEMPERATURE SENSOR MODE/SET and UP/DOWN Switch Assembly Replacement 1. Remove steering cover, refer to STEERING AND O.T.A.S. 2. Disconnect connector from switch assembly.
The water temperature sensor is located within the iBR module that is part of the iBR actuator. It cannot be tested or replaced separately. Water from the jet pump passes through the iBR actuator where the sensor measures its tempera- ture, generating a signal that is interpreted by the iBR module. The iBR module then sends the in- formation through the can-bus to the information center that translates it into a temperature indica- tion. If the temperature sensor is defective, the tem- perature indication will not be displayed and a WATER TEMP SENSOR DEFECTIVE message will scroll in the multifunction display.
A lake water temperature sensor fault code should be generated if the sensor is defective. Refer to MONITORING SYSTEM AND FAULT CODES. If the lake water temp sensor is defective, replace the iBR actuator. smr2009-036-013_a 1. MODE/SET, and UP/DOWN switch connector 3. Remove switch assembly from support by lift- ing it off the support. 4. Ensure wiring from cruise switch is prop- erly inserted in slot provided before installing MODE/SET and UP/DOWN arrow switch as- sembly. smr2009-036-014_a 1. Cruise switch 2. Wiring in slot provided in support 3. MODE/SET and UP/DOWN arrow switch connector 5. Apply a small amount of DIELECTRIC GREASE (P/N 293 550 004) on switch contact pins. 354 smr2009-036