Section 02 ENGINE Subsection 01 (ENGINE REMOVAL AND INSTALLATION) ENGINE REMOVAL AND INSTALLATION SERVICE TOOLS Description Part Number Page ALIGNMENT SHAFT ADAPTER .................................................... 529 035 719 ..................................... 20–21 ALIGNMENT SHAFT SUPPORT .................................................... 529 035 506 ........................................... 21 ALIGNMENT SHAFT ..................................................................... 295 000 141 .....................................20, 22 ENGINE ALIGNMENT PLATE........................................................ 529 036 170 ...........................................
21 FUEL HOSE DISCONNECT TOOL ................................................ 529 036 037 ........................................... 17 SERVICE PRODUCTS Description Part Number Page LOCTITE 243 (BLUE)..................................................................... 293 800 060 .....................................20, 23 PULLEY FLANGE CLEANER ......................................................... 413 711 809 ........................................... 20 GENERAL During assembly/installation, use torque values and service products from exploded views in the appropriate sections. Clean threads before applying a threadlocker.
Re- fer to SELF-LOCKING FASTENER and LOCTITE APPLICATION at the beginning of this manual for complete procedure. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pin, etc.) must be replaced with new ones. smr2009-016-001_a 1. Vent box 2. Retaining latches 4. Remove the deck extension. Refer to BODY subsection. Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards. PROCEDURES ENGINE Engine Removal 1. Place vehicle at workstation that will have ac- cess to a chain block, a hoist or other suitable lifting equipment. 2.
Remove the moving deck. Refer to BODY sub- section. 3. Remove the rear ventilation box. smr2009-016-002_a 1. Deck extension 5. Remove the air intake silencer. Refer to AIR IN- TAKE SYSTEM subsection. smr2009-016 15