Section 06 STEERING AND PROPULSION Subsection 01 (STEERING AND O.T.A.S.) GENERAL ADJUSTMENT During assembly/installation, use torque values and service products as in the exploded view. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. STEERING ALIGNMENT Raise the iBR gate by activating the iBR override function. Refer to IBR AND VTS subsection. Install two bungee cords to maintain steering dur- ing the procedure. Position steering so that the edge of the steering column cover and edge of the gauge support are equal.
WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced with new ones. Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards. SYSTEM DESCRIPTION (O.T.A.S.) The O.T.A.S. (Off-Throttle Assisted Steering) pro- vides additional maneuverability in off-throttle sit- uations. The system uses a pair of magnets mounts on the steering column and a Hall effect switch mounts underneath steering column support. When activated by a magnet, the O.T.A.S. switch sends a signal to the ECM.
The ECM activates a pre- programmed RPM set- ting when the driver initiates a full turn after relea- sing throttle lever. The engine RPM is controlled by the intelligent Throttle Control (iTC). The O.T.A.S. system is activated when the follow- ing conditions are achieved: The engine speed must be above 4000 RPM for at least 1.5 second (approximately). The throttle lever must be released completely. The steering must be fully turned within approx- imately 4 seconds after throttle release. The O.T.A.S. will stay activated for a random period of time as long as the O.T.A.S. switch is closed. O.T.A.S. will be deactivated if:
The throttle is reapplied, or The steering is turned sufficiently to open the O.T.A.S. switch for more than one second. smr2009-037-055_a 1. Steering column cover edge 2. Gauge support edge Check jet pump nozzle position by placing a straight edge on nozzle outer end. Measure the distance on each side of the straight edge. It must be equalled. smr2009-037-003_a 1. Straight edge places against nozzle If necessary, steering alignment adjustment should be performed at steering column. Open storage compartment cover and remove basket. Loosen steering column clamp bolts securing the steering cable clamp at the bottom of steering col- umn. Turn adjusting nut as required. smr2009-037 361