Section 06 STEERING AND PROPULSION Subsection 01 (STEERING AND O.T.A.S.) smr2009-037-041_a 1. Nozzle 2. Nozzle arm 3. Hexagonal screw 4. Nozzle link rod 5. Socket screw 6. VTS trim ring smr2009-037-007_a 1. Grip insert NOTE: Verify grip insert for damage. Handlebar Grip Installation When installing the grip insert in the handlebar, ensure that it is properly inserted in the slot at the end of the handlebar tubing. Remove nozzle from watercraft. Nozzle Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on hexagonal screw threads (or use new self-locking screws).
Tighten hexagonal screws to 10 N•m (89 lbf• in ). Secure steering cable to nozzle. Refer to STEER- ING CABLE in this subsection. Perform the STEERING ALIGNMENT, see the pro- cedure in this subsection. smr2009-037-008_a 1. Grip insert HANDLEBAR GRIP Handlebar Grip Removal To remove handlebar grip, pull out cap and remove screw. Install handlebar grip on handlebar matching it to the notch in the handlebar. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on screw threads. Install flat washer and handlebar grip screw. NOTICE Ensure to install flat washer other- wise screw will damage grip end. Torque handlebar grip screw to 7 N•m (62 lbf• in ). Install cap. smr2009-037-006_a 1. Handlebar grip 2.
Handlebar grip screw Pull out handlebar grip and remove grip insert from handlebar. smr2009-037 363