Section 06 STEERING AND PROPULSION Subsection 01 (STEERING AND O.T.A.S.) 3. Unlock steering cover from steering. 3.1 Insert a small tool, such as an Allen key, into a steering cover hole. Press the tool against the retaining tab to unlock it. Re- peat for the other side. 3.4 Remove foam inside the steering cover. 3.5 Remove D.E.S.S. post from steering cover. Steering Cover Installation 1. Install the D.E.S.S. post. 1.1 Index the alignment pin of the D.E.S.S. post with the notch of steering cover. NOTICE The tool must be inserted per- fectly straight to avoid breaking the tab holder. smr2009-037-013_a 1. Allen key smr2009-037-017_a 1.
Steering cover notch 3.2 In both cavities at the back of steering cover, release both inner retaining tabs using a long screwdriver. 1.2 Press the D.E.S.S. post until retaining tab is positioned correctly. smr2009-037-018_a 1. Retaining tab smr2009-037-014_a 1. Rear cavity 2. Install D.E.S.S. post nut and tighten it to 2 N•m (18 lbf• in ). 3. Install the foam. 4. Place the D.E.S.S. harness in foam slot. 5. Install the steering cover. 5.1 Check if all harnesses are route properly. All harness must be inserted in its slot. 3.3 Release the five retaining tabs at the rear of steering smr2009-037-016_a 1. Retaining tabs smr2009-037 365