Section 06 STEERING AND PROPULSION Subsection 01 (STEERING AND O.T.A.S.) smr2009-037-019_a 1. Harness slots smr2009-037-031_a 1. Retaining screw 2. Washer 3. Bushings 4. Throttle lever 5.2 Clip the top of the cover. 5.3 Stretch the bottom of the steering cover until the cover edge passes over the inner ribs. 4. Clean throttle lever area from dust or any de- posits. 5. Apply XPS SYNTHETIC GREASE (P/N 293 550 010) on shaft that receives throttle lever and on the end of the return tab. smr2009-037-020_a STEERING REMOVED FOR CLARITY PURPOSE 1. Inner ribs smr2009-037-032_a 1. Apply grease here 5.4 Push both side of the cover to lock it with the steering column. 5.5 Install switch covers. 6.
Install the lever. 6.1 Install both bushings in lever hole. 6.2 Insert sensor lever end into throttle lever fork. 6.3 Position the return tab against the handle- bar. 6.4 Secure the lever with washer and screw. 6.5 Tighten the lever screw to 0.7 N•m (6 lbf• in ). 7. Reinstall all removed parts using appropriate procedure. THROTTLE AND iBR LEVERS NOTE: The following procedure demonstrates the replacement of the throttle lever but the same procedure will be used for the iBR lever. Lever Replacement 1. Remove STEERING COVER, see procedure in this subsection. 2. Remove the screw and washer securing throt- tle lever. 3. Remove throttle lever and its bushings.
STEERING CABLE Steering Cable Replacement 1. Remove the moving deck. Refer to BODY sub- section. 366 smr2009-037