Section 06 STEERING AND PROPULSION Subsection 01 (STEERING AND O.T.A.S.) 2. Remove the adjusting nut from steering cable end. 3. At the rear of the vehicle, disconnect ball joint from jet pump nozzle arm. smr2009-037-022_a 1. Steering cable 2. Steering cable nut 6. Remove steering cable nut, half rings and O-ring. smr2009-037-004_a 1. Steering cable bolt 2. Nozzle arm 4. Remove ball joint and jam nut from cable. smr2009-037-023_a PUMP AND IBR SYSTEM REMOVED FOR CLARITY PURPOSE ONLY 1. Steering cable 2. Steering cable nut 3. Half rings 4. O-ring 7. Remove the adjusting nut from the new steer- ing cable. 8. Using a piece of hose, attach one end of each cable together. NOTE:
Ensure to attach different ends together to avoid installing the new cable in the wrong way. 9. Pull the old cable slowly through the vehicle then separate cable ends. 10. Secure the steering cable to hull fitting. 10.1 Install O-ring and half rings. 10.2 Secure steering cable with the steering cable nut. 10.3 Tighten nut to 6 N•m (53 lbf• in ). 11. Install the ball joint on the end of the steering cable. 11.1 The threaded portion of steering cable in- serts into ball joint should have between 9 mm ± 1 mm (.354 in ± .039 in). smr2009-037-021_a 1. Steering cable 2. Jam nut 3. Ball joint 5. Using the STEERING CABLE TOOL (P/N 295 000 145) , loosen steering cable nut. 295000145 smr2009-037 367