Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 01 (STEERING AND O.T.A.S.) 2. Remove the gauge support. Refer to GAUGE subsection. 3. Disconnect the four connectors under moving deck. smr2006-031-006_a A. 9 mm ± 1 mm (.354 in ± .039 in) 11.2 Tighten jam nut to 2.5 N•m (22 lbf• in ). 11.3 Position the steering cable ball joint to the nozzle as per following illustration. smr2009-042-005_a 1. Disconnect these connectors 4. Remove both screws securing the steering col- umn. smr2009-037-025_a 1. Ball joint bolt 2. Ball joint under nozzle arm 3. Washer 4. Nut 11.4 Tighten ball joint nut to 6 N•m (53 lbf• in ). 12. Check if the cable bellows is properly posi- tioned all around steering cable.

smr2009-037-027_a 1. Steering column screws 5. Pull steering column out of its support. Ensure to not damage wiring harness connectors and O.T.A.S. magnets. Steering Column Inspection Check steering column for: Cracks Stress marks Wear indications. Replace the steering as required. Check both wear bushings in steering column support. Replace if necessary. smr2009-037-026_a 1. Check fit 13. Reinstall the moving deck. Refer to BODY subsection for complete procedure. 14. Check steering alignment. STEERING COLUMN Steering Column Removal 1. Open the front storage cover and remove the storage basket. 368 smr2009-037