Section 06 STEERING AND PROPULSION Subsection 01 (STEERING AND O.T.A.S.) 3. On both side of vehicle, remove both pivot bushings (steering column support and steer- ing adjustment handle). smr2009-037-028_a 1. Upper bushing 2. Steering column support 3. Lower bushing Check wear sleeve behind the steering column arm. smr2009-037-033_a 1. Pivot bushing of steering column support 2. Pivot bushing of steering adjustment handle NOTE: Pivot bushings retaining steering column could be hard to remove, in this case remove the retaining screw from the center hole and tighten it into the offset hole. Tighten screw until the pivot bushing comes out of steering column support. smr2009-037-029_a 1.
Wear sleeve 2. Steering column arm 3. Steering column support Steering Column Installation The installation is essentially the reverse of the re- moval procedure. However, pay attention to the following. Carefully, drive steering column through steering column support. Ensure to not hit the O.T.A.S. magnet during steering column installation. Tighten steering column screws to 6 N•m (53 lbf• in ). Reinstall all removed parts using appropriate pro- cedure. smr2009-037-040_a 1. Center hole 2. Offset hole 4. Remove steering column support and steering adjustment handle from vehicle. 5. Remove STEERING COLUMN from its support. See the procedure in this subsection.
Steering Column Support Installation The installation is the reverse of the removal pro- cedure. STEERING COLUMN SUPPORT Steering Column Support Removal 1. Refer to BODY and remove the following parts: Storage cover Front grille Body covers. 2. Remove the gauge support. Refer to GAUGE subsection. STEERING TILT ADJUSTMENT HANDLE Steering Tilt Adjustment Handle Replacement Use the same procedure as for STEERING COL- UMN SUPPORT. smr2009-037 369