Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 01 (STEERING AND O.T.A.S.) O.T.A.S. SWITCH O.T.A.S. Switch Power Wire Continuity Test Check continuity between O.T.A.S. switch 3-pin connector and fuse block (FB1). O.T.A.S. Switch Dynamic Test Connect B.U.D.S. software. Refer to COMMUNI- CATION TOOLS AND B.U.D.S. SOFTWARE sub- section. Briefly press the START/STOP button to wake up the ECM. Install the D.E.S.S. key on its post. Completely turn steering in one direction and keep it in this position. Look in B.U.D.S. to see if the O.T.A.S. system turns on. If there is no continuity, check fuse 6 (FB1), wiring, connector and terminals. If continuity is good, check continuity of the O.T.A.S.

switch ground wire. O.T.A.S. Switch Ground Wire Continuity Test Check continuity between O.T.A.S. switch 3-pin connector and ECM connector "B" using the ECM ADAPTER TOOL (P/N 529 036 166) smr2009-037-034_a MONITORING AND IBR TABS 1. O.T.A.S. "LED" Repeat test for the other side. If O.T.A.S. system does not turn on, check for fault codes then check other tests for the O.T.A.S. switch. smr2009-037-024_a O.T.A.S. Switch Voltage Test Press the START/STOP button to activate the electrical system. Using the FLUKE 115 MULTIMETER (P/N 529 035 868) , perform the following test. If continuity is good, check ECM ground. Refer to POWER DISTRIBUTION subsection for complete procedure.

If there is no continuity, repair or replace wiring, connector or terminals. O.T.A.S. Switch Continuity Test Unplug the pin "C" from the 3-pin connector. Briefly press on START/STOP button to wake up the ECM. Measure the resistance of switch as follows. If there is voltage present, carry out the O.T.A.S. switch continuity test. If there is no voltage, check continuity of the O.T.A.S. switch power wire. 370 smr2009-037 3-PIN CONNECTOR FUSE BLOCK (FB1) RESISTANCE PIN "A" C3 .5 3-PIN CONNECTOR ECM ADAPTER TOOL RESISTANCE PIN "B" H3 .5 TEST PROBES VOLTAGE (VDC) PIN "A" (3-pin connector) PIN "B" (3-pin connector) Battery voltage