Section 06 STEERING AND PROPULSION Subsection 01 (STEERING AND O.T.A.S.) O.T.A.S. MAGNETS Magnets Replacement 1. Remove STEERING COLUMN, see procedure in this subsection. 2. Remove wiring harness from the center of steering column. 3. Using a long tool, press on retaining tabs to re- lease the magnets. If continuity test is out of specification, try any good magnet and bring it in front of the switch. If continuity test is now good, replace the magnets. If continuity test is still out of specification with a new magnet, check wires, connectors and termi- nals. If all is good, replace the O.T.A.S. switch. O.T.A.S. Switch Replacement 1.
Remove STEERING COLUMN SUPPORT, see procedure in this subsection. 2. Remove steering column from its support by removing both retaining screws. smr2009-037-039_a 1. Magnets 2. Retaining tabs 3. Lower end of steering column Reverse removal procedure to reinstall the mag- nets. smr2009-037-027_a 1. Steering column screws 3. Using a small screwdriver, unlatch the switch from steering support. smr2009-037-038_a 1. Switch retaining tabs Reverse removal procedure to reinstall the O.T.A.S. switch. smr2009-037 371 STEERING POSITION MULTIMETER LEAD POSITION RESISTANCE Center position Pin "C" and vehicle ground 1935 - 2365 Fully turned 324 - 396