Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) smr2009-036-004_c 1. Forward ventilation box 2. 12 pin steering connector to disconnect 3. 6 pin steering connector to disconnect smr2009-038-003_b Step 1: Disconnect the 12 pin connector NOTE: Connecting the DIAGNOSTIC HARNESS (P/N 529 036 179) to the steering connectors (steering side only then vehicle side only) will facilitate access. Resistance readings may be slightly higher than normal (maximum .5 ) with test harness installed. 6. Measure for continuity from the BRLS connec- tor to the 12 pin iBR actuator connector as per following table. If continuity is good, replace BRLS.

If an open circuit or a higher than normal resis- tance is measured, carry out the following conti- nuity tests to find the problem wire or connection: From the BRLS to the steering connectors (C01-12 POS and C03-6 POS) From the steering connectors to the iBR actua- tor 12 pin connector.

386 smr2009-037 CONTINUITY TEST OF BRLS WIRING HARNESS BRLS CONNECTOR 12 PIN iBR CONNECTOR RESISTANCE Pin A (VI/YL) Pin 4 (VI/YL) Close to 0 (continuity) Pin B (BK) Pin 6 (BK) Pin C (YL/BK) Pin 8 (YL/BK) Pin D (VI/YL) Pin 7 (VI/YL) Pin E (BK) Pin 9 (BK) Pin F (YL/WH) Pin 5 (YL/WH) CONTINUITY TEST BRLS TO STEERING CONNECTORS BRLS 12 PIN STEERING 6 PIN STEERING RESISTANCE Pin A (VI/YL) - Pin 4 (VI/YL) Close to 0 (continuity) Pin B (BK) - Pin 5 (BK) Pin C (YL/BK) - Pin 6 (YL/BK) Pin D (VI/YL) Pin 5 (VI/YL) - Pin E (BK) Pin 4 (BK) - Pin F (YL/WH) Pin 3 (YL/WH) -