Section 06 STEERING AND PROPULSION Subsection 02 (iBR AND VTS) fault may be within the gauge. Replace the gauge and carry out a new VTS BUTTON TEST USING B.U.D.S. to ensure the problem is solved. VTS Control Button Removal NOTE: The VTS and iS control s come as a switch assembly which must be replaced as a unit. 1. Remove steering cover, refer to STEERING AND O.T.A.S. 2. Remove connector from switch assembly. vmr2006-020-005 NOTE: Pay attention to multimeter lead position for diode biasing during test. Remember that each diode should drop approximately 0.6 Vdc when positively biassed, and read as an OL (open circuit) when negatively biassed (leads reversed). smr2009-038-034_a 1.
VTS/iS switch connector 3. Remove switch assembly from support by lift- ing it off the support. VTS Control Button Installation 1. Apply a small amount of DIELECTRIC GREASE (P/N 293 550 004) on switch contact pins. 2. Install connector on new switch assembly. 3. Ensure wiring from START switch is properly inserted in slot provided before installing VTS and iS control button assembly. When measuring between pins 13 and 15, if an OL is obtained with both positive and negative diode biassing, test the continuity of each wire between the gauge and switch assembly. If con- tinuity is good, replace the switch assembly.
If any reading is significantly different than speci- fied, carry out the same test at the switch connec- tor, refer to the wiring diagram. If you obtain the same results, replace the switch assembly. If voltages measured on the VTS UP and DOWN switch are as specified (or very close to it), the switches and the wiring harness are good. The smr2009-037 405 VTS CONTROL TEST SWITCH POSITION MULTIMETER LEAD GAUGE CONNECTOR VOLTAGE Switch released Red lead Black lead Pin 13 Pin 15 Approx. 2 Vdc Black lead Red lead Pin 13 Pin 15 OL UP depressed Red lead Black lead Pin 13 Pin 15 Approx. 1.1 Vdc Black lead Red lead Pin 13 Pin 15 OL DOWN depressed Red lead Black lead Pin 13 Pin 15 Approx.
1.6 Vdc Black lead Red lead Pin 13 Pin 15 OL