Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 03 (JET PUMP) GENERAL During assembly/installation, use torque values and service products as in the exploded views. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENER and LOCTITE APPLICATION at the beginning of this manual for complete procedure. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced. smr2007-028-001_a TYPICAL UNDERNEATH HULL 1. Impeller 2. Impeller boot 3.

Wear ring IMPELLER/WEAR RING CLEARANCE JET PUMP MAIN COMPONENTS This clearance is critical for jet pump performance. To check clearance, remove jet pump. Using a feeler gauge, measure clearance between impeller blade tip and wear ring. Measure each blade at its center. : smr2006-027-011_a TYPICAL 1. Nozzle 2. Venturi 3. Jet pump housing 4. Wear ring 5. Impeller 6. Stator smr2006-027-008 INSPECTION IMPELLER CONDITION IMPELLER SHAFT RADIAL PLAY Condition of impeller, impeller boot and wear ring can be quickly checked from underneath the watercraft. With the vehicle on the trailer, use a flashlight to visually inspect them through the inlet grate. Radial play is critical for jet pump life span.

To check radial play, remove jet pump. Make sure impeller shaft turns freely and smoothly. 1. Retain housing in a soft jaw vise making sure not to damage housing lug. 2. Set a dial gauge and position its tip onto metal end, close to the end of the impeller hub. 3. Move shaft end up and down. Difference be- tween highest and lowest dial gauge reading is radial play. smr2009-039 409 MODEL MAXIMUM WEAR CLEARANCE mm (in) All models 0.35 (.014)