Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 03 (JET PUMP) 3. Install impeller cover by aligning the cover index mark with the pump top fin as shown. sdd2009-001-114_c 1. Align mark with top fin NOTE: Cover can only be installed in one position as screw holes are not located symmetrically. 4. Secure cover with NEW self-locking screws. NOTE: Push cover against pump housing while alternately tightening screws. Make sure O-rings are positioned correctly and they are not damaged when pushing the cover. 5. Torque cover screws to 7.5 N•m (66 lbf• in ). 6. Perform a leak test. Refer to LEAK TEST in this subsection. ' TYPICAL 1. Unscrew clockwise 4. Mount the flat sides of impeller shaft in a vise.

IMPELLER Impeller Removal NOTE: If impeller shaft is to be disassembled, loosen the impeller shaft nut prior to removing the impeller. 1. Remove jet pump from the watercraft. Refer to JET PUMP HOUSING in this subsection. 2. Remove impeller cover. Refer to IMPELLER COVER in this subsection. 3. Remove impeller boot by turning it clockwise (LH threads). smr2009-006-005_a TYPICAL 1. Flat side 5. Mount in the impeller splines the appropriate impeller remover/installer tool according to en- gine type. 416 smr2009-039 MODEL TOOL 130 and 155 engines IMPELLER REMOVER/INSTALLER (P/N 529 035 820) 215 and 255 engines IMPELLER REMOVER/INSTALLER (P/N 529 035 956)