Section 06 STEERING AND PROPULSION Subsection 03 (JET PUMP) WEAR RING Wear Ring Inspection Check wear ring for: Deep scratches Irregular surface Any apparent damage. Check IMPELLER/WEAR RING CLEARANCE, see procedure at the beginning of this subsection. Wear Ring Removal 1. Remove the iBR gate, VTS trim ring and the steering nozzle as an assembly. See procedure in IBR AND VTS subsection. 2. Remove jet pump from watercraft. Refer to JET PUMP HOUSING in this subsection. 3. Remove impeller from jet pump housing, refer to IMPELLER in this subsection. 4. Place jet pump housing in a vise with soft jaws. It is best to clamp housing using a lower ear. 5. Cut wear ring at two places.
smr2009-006-007 TYPICAL 5. Mount in the impeller splines the appropriate impeller remover/installer tool according to en- gine type. NOTICE When cutting ring, be careful not to damage jet pump housing. 6. Torque impeller to 125 N•m (92 lbf•ft), then re- move tool. NOTE: Wear ring can be cut using a jigsaw, a small grinder or a low clearance hacksaw. 6. After cutting ring, insert a screwdriver blade be- tween jet pump housing and ring outside diam- eter. 7. Push ring so that it can collapse internally. 8. Pull ring out. NOTICE Never use an impact wrench to tighten impeller shaft.
Wear Ring Installation To install wear ring in housing, use a square steel plate of approximately 180 x 180 mm x 6 mm thick (7 x 7 in x 1/4 in) and a press. Manually engage ring in housing making sure it is equally inserted all around. Press ring until it seats into bottom of housing. smr2009-006-006_a TYPICAL 7. Apply LOCTITE 577 (THREAD SEALANT) (P/N 293 800 050) on impeller boot threads. 8. Apply XPS SYNTHETIC GREASE (P/N 293 550 010) inside impeller boot. 9. Install impeller boot on impeller and tighten counterclockwise. 418 smr2009-039 MODEL TOOL 130 and 155 engines IMPELLER REMOVER/INSTALLER (P/N 529 035 820) 215 and 255 engines IMPELLER REMOVER/INSTALLER (P/N 529 035 956)