Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 03 (JET PUMP) 2. Mount in a vise the appropriate impeller re- mover/installer tool according to engine type. ' 1. Rounded edge 2. Press wear ring If a press is not readily available, a piece of wood such as a 2 x 4 in x 12 in long, can be used. Manually engage ring in housing making sure it is equally inserted all around. Place wood piece over ring. Using a hammer, strike on wood to push ring. Strike one side then rotate wood piece about 90° and strike again. Frequently rotate wood piece so that ring slides in evenly until it seats into bottom of housing. 6 A$; TYPICAL 1. Impeller remover/installer tool 3.

Install jet pump housing over impeller re- mover/installer tool. 6 A 6 ' 1. Piece of wood 2. Rounded edge 3. Wear ring 4. Using a 30 mm socket, unscrew the impeller shaft nut counterclockwise. NOTE: If impeller loosens instead of shaft nut, refer to IMPELLER SHAFT NUT REMOVAL IF IMPELLER HAS LOOSENED further in this pro- cedure. TYPICAL IMPELLER SHAFT AND BEARING Impeller Shaft and Bearing Removal 1. Remove impeller cover. Refer to IMPELLER COVER in this subsection. smr2009-039 419 MODEL TOOL 130 and 155 engines IMPELLER REMOVER/INSTALLER (P/N 529 035 820) 215 and 255 engines IMPELLER REMOVER/INSTALLER (P/N 529 035 956)