Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 03 (JET PUMP) smr2009-006-019_a TYPICAL 1. Threads 2. Seal lip contact surface 3. Threads Inspect ball bearing for corrosion. Impeller Shaft and Bearing Installation smr2009-006-014_a TYPICAL 1. Bearing tool 2. Impeller shaft and bearing Bearing Installation The installation is essentially the reverse of the re- moval procedure. However, pay attention to the following. 1. Using the IMPELLER SHAFT BEARING TOOL (P/N 529 036 168) on the bearing inner race, press the bearing on the impeller shaft. 2. Use the IMPELLER SHAFT PUSHER (P/N 529 035 955) to protect the impeller shaft threads. NOTE: The bearing can be installed in either direc- tion. 2.

Press bearing until it bottoms. NOTE: Ensure impeller shaft turns freely and smoothly. 3. Turn pump upside down. 4. Coat shaft surface with JET PUMP BEARING GREASE (P/N 293 550 032) . 5. Install O-ring at bottom. 6 (A9 smr2009-006-013_a TYPICAL 1. Impeller shaft bearing tool on INNER race 2. Impeller shaft and bearing 3. Impeller shaft installer/pusher tool TYPICAL 1. O-ring at bottom 2. Coat surface 6. Apply 4 ml (.1 U.S. oz) of JET PUMP BEARING GREASE (P/N 293 550 032) on bearing. 3. Press bearing until it bottoms. Impeller Shaft Installation NOTE: Ensure there is no O-ring in pump housing on the cover side. 1.

From the outlet side of pump, press impeller shaft assembly into housing using the IM- PELLER SHAFT BEARING TOOL (P/N 529 036 168) . 422 smr2009-039