Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 04 (DRIVE SHAFT) GENERAL The jet pump must be removed to replace any component of the drive system. Refer to JET PUMP for removal procedure. During assembly/installation, use torque values and service products as specified in the exploded view. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced with new ones. smr2009-007-012_a WRONG 1.

Rubber sealing lip NOT fully engaged TROUBLESHOOTING DIAGNOSTIC TIPS Leaks at PTO Seal If water enters engine, or oil leaks from engine at PTO seal, check if drive shaft is fully engaged in sealing ring. Compress the drive shaft boot to visually check for proper contact. smr2009-007-013_a CORRECT 1. Rubber sealing lip fully engaged NOTE: If drive shaft boot cannot be compressed enough for the inspection, remove jet pump and torque drive shaft. If this does not work, remove drive shaft and inspect drive shaft threads. Refer to DRIVE SHAFT in this subsection. smr2009-010_a 1. Drive shaft boot Rubber sealing lip of drive shaft must be fully en- gaged into flange of sealing ring. smr2009-040 429