Section 06 STEERING AND PROPULSION Subsection 04 (DRIVE SHAFT) PROCEDURES DRIVE SHAFT Drive Shaft Removal To prevent oil spillage when pulling out drive shaft, carry out the following: Start engine. Bring engine to 4000 RPM for 10 seconds. Stop engine at this RPM. NOTE: If engine cannot be started, remove oil from the PTO area by following the procedure detailed in PTO HOUSING REMOVAL of the PTO HOUSING AND MAGNETO subsection. 1. Position watercraft at a workstation that has ac- cess to a chain block, a hoist or other suitable lifting equipment. 2. Disconnect the rear control arm and tilt the moving deck forward fir access. Refer to BODY subsection. 3.
Remove the aft ventilation box located above the engine. smr2009-016-002_a 1. Deck extension 5. Lower the moving deck onto the fixed deck and install a few hexagonal screws on the aft con- trol arm to hold the deck steady for the duration of the procedures. 6. Remove the air intake silencer. Refer to AIR IN- TAKE SYSTEM subsection. 7. Remove the iBR gate and VTS ring as an assem- bly. Refer to IBR AND VTS subsection. 8. Remove the jet pump assembly. Refer to JET PUMP subsection. 9. Reach in behind the engine and lift the rubber protector to expose the PTO seal at the engine side of the driveshaft. smr2009-016-001_a 1. Vent box 2. Retaining latches 4. Remove the deck extension.
Refer to BODY subsection. smr2009-040-002_a 1. Rubber protector 430 smr2009-040