Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 04 (DRIVE SHAFT) smr2009-007-006_a 1. Splines 2. Threads 3. Taper 4. Rubber sealing lip 5. Rubber coating smr2009-007-003_b TYPICAL - CLOCKWISE TO UNSCREW 4. Measure drive shaft deflection. Excessive de- flection could cause vibration and damage to drive shaft splines, impeller or PTO seal. 5. Place drive shaft on V-blocks and set-up a dial gauge in center of shaft. Slowly rotate shaft; difference between highest and lowest dial gauge reading is deflection. Refer to the fol- lowing illustration. 6. IMPORTANT: When rotating drive shaft and reading the deflection, the gauge needle will bump on the molding flash mark.

This is a normal situation, ignore this deflection peak. CAUTION Ensure to unscrew clockwise on LH threads (opposite of usual threads). 14. Place rags under PTO housing to prevent oil spillage. If spillage occurs, clean immediately with the PULLEY FLANGE CLEANER (P/N 413 711 809) to prevent oil stains. 15. Pull out drive shaft. NOTE: A slight jerk to the rear may be required to remove the drive shaft from the PTO seal. 16. Remove sealing ring. Refer to SEALING RING in this subsection. Drive Shaft Inspection 1. Inspect condition of drive shaft splines, taper surface and threads. If damage is found, re- place drive shaft. 2. Carefully inspect the rubber sealing lip condi- tion.

Damage would allow water to enter en- gine or oil to leave engine. If damaged, replace drive shaft. CAUTION The rubber sealing lip is critical for proper sealing of engine at drive shaft con- nection into engine. 3. Inspect the rubber coating of drive shaft. If cracked or otherwise damaged, shaft corrosion will occur. smr2009-007-200_a TYPICAL MEASURING DRIVE SHAFT DEFLECTION 1. Dial gauge 2. V-blocks DRIVE SHAFT DEFLECTION Maximun .75 mm (.03 in) Drive Shaft Installation 1. Install sealing ring. Refer to SEALING RING subsection. 432 smr2009-040