Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 04 (DRIVE SHAFT) 2. Remove the damper at the end of drive shaft and replace it with a NEW one. smr2009-007-010_a LOCTITE 577 APPLICATION A. First 5 threads B. 3 mm (1/8 in) 8. From rear of watercraft, engage drive shaft through the drive shaft boot. 9. Continue pushing drive shaft towards engine carefully guiding it through the sealing ring, the PTO seal and finally into the crankshaft splines. NOTE: It may be necessary to move sealing ring and PTO seal up and down to position them in the same axis as the drive shaft. NOTE: If drive shaft does not enter into the PTO seal, check engine alignment. Refer to ENGINE subsection. 10.

Trace an index mark on the drive shaft which will be used for counting the turns the drive shaft will be rotated to fully engage drive shaft. smr2006-028-004_a 1. Damper 3. Wipe clean the sealing ring and the carbon seal contact surfaces. 4. Properly align sealing ring with carbon seal. smr2009-007-001_b 1. Sealing ring aligned with carbon seal smr2009-007-014_a 1. Mark 5. Wipe clean the threads and the tapered surface on drive shaft. 6. Apply engine oil to the tapered surface on drive shaft. 11. Install the DRIVE SHAFT ADAPTER (P/N 529 035 985) on drive shaft end. smr2009-007-016_a 1. Clean taper then coat with engine oil 7.

Apply 2 beads of LOCTITE 577 (THREAD SEALANT) (P/N 293 800 050) on threads as shown. smr2009-040 433