Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 06 STEERING AND PROPULSION Subsection 04 (DRIVE SHAFT) smr2009-007-003_a TYPICAL 1. Drive shaft adapter smr2009-007-002_a TYPICAL 1. Drive shaft wrench NOTE: Make sure all spark plugs are removed from engine. 12. Removing spark plugs helps to engage threads more easily thus preventing cross-threading the sealing ring. Carefully rotate drive shaft counterclockwise (LH threads) to engage threads in sealing ring. Be careful not to engage cross-thread. 15. While a coworker holds the drive shaft wrench in engine compartment, continue turning drive shaft counterclockwise (LH threads) to a total of 8 turns. 16. IMPORTANT:

The number of turns is only a reference to give you an idea of the drive shaft engagement in the sealing ring. It is useful if you suspect cross-threading. When the num- ber of turns has been reached, the torque is mandatory to properly secure the drive shaft. smr2009-007-003_c TYPICAL smr2009-007-003_c 13. Rotate drive shaft 1-1/2 to 2 turns then try pulling drive shaft out to ensure it is engaged. 14. In engine compartment, install the DRIVE SHAFT WRENCH (P/N 529 036 167) on the hexagon of sealing ring. 17. Torque drive shaft to 125 N•m (92 lbf•ft). 18. Reposition rubber protector above sealing ring. 19. Install jet pump. Refer to JET PUMP section. 20.

Install iBR gate and VTS ring, refer to IBR AND VTS subsection. 21. Check engine oil level. Refill as necessary. 22. Install spark plugs on engine, refer to ENGINE subsection. 434 smr2009-040