Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) GENERAL NOTE: For a complete overview of the vehicle electrical system, refer to POWER DISTRIBU- TION subsection. It is highly recommended to disconnect the bat- tery when replacing any electric or electronic com- ponent. WARNING Always disconnect battery exactly in the specified order, BLACK (-) cable first, RED (+) cable last. Always reconnect BLACK (-) cable last. Do not place tools on battery. sdd2009-001-206_b 1. Rear suspension arm 2. Front suspension arm 3. Springs 4. Shock absorber SYSTEM DESCRIPTION An actuator is mounted underneath springs to control the spring preload and therefore the sus- pension height.
The intelligent suspension is a mechanical system of two springs and one shock absorber installed in the fixed deck connecting to the moving deck to isolate the riders from the rough water. smr2009-041-038_a 1. Springs 2. Actuator smr2009-041-080 MOVING DECK The iS module controls the electric motor of the hydraulic pump to adjust the actuator height. It also sets the suspension height according to the active mode of operation and input signals. sdd2009-001-202 FIXED DECK smr2009-041-039_a REAR STARBOARD SIDE 1.
iS module The iS module is programmed with various param- eters that it compares to the input signals and in- formation it obtains through the CAN bus from the other electronic modules. 440 smr2009-041