Section 07 BODY AND HULL Subsection 01 (SUSPENSION (iS)) The suspension can be set to the AUTO or MAN- UAL mode. In AUTO mode, suspension height is factory preset and the iS module constantly monitors the stroke of the suspension and it automatically readjusts suspension height for changing water conditions and passenger load. In MANUAL mode, the driver may choose to set the suspension higher or lower by using the UP and DOWN s on the handlebar. A DOCK mode is available where the suspension is set to its lowest position. Circuit Testing Check the related-circuit fuse condition with a fuse tester or ohmmeter (relying solely on a visual inspection could lead to an incorrect con- clusion).
Electrical Connection Inspection When replacing an electric or electronic compo- nent, always check electrical connections. Make sure they are tight, make good contact, and are corrosion-free. Dirty, loose or corroded contacts are poor conductors and are often the source of a system or component malfunction. Pay particular attention to ensure that pins are not bent or pushed out of their connectors. Ensure all wire terminals are properly crimped on wires, and connector housings are properly fas- tened. Check for signs of moisture, corrosion or dullness.
Clean pins properly and coat them with DIELEC- TRIC GREASE (P/N 293 550 004) or other appropri- ate lubricant (except if otherwise specified) when reassembling them. Pay attention to the ground wire connections are clean, tight and free of corrosion. TROUBLESHOOTING DIAGNOSTIC TIPS It is important to determine first if the problem is electrical or mechanical related. If you hear the hy- draulic motor running when pressing the steering suspension , check for related mechanical prob- lem. NOTE: It is a good practice to check for fault codes using B.U.D.S. software as a first trou- bleshooting step when suspecting an electrical problem. Refer to COMMUNICATION TOOLS AND B.U.D.S.
SOFTWARE subsection. IMPORTANT: When troubleshooting an electrical system fault, check battery condition, cables and connections first. DIAGNOSTIC GUIDELINES The following is provided to help in diagnosing the probable source of troubles. It is a guideline and it should not be assumed to list all possible prob- lems. Electrical System Activation 1. Press the START/STOP button. NOTE: Pressing the START/STOP button without the D.E.S.S. key installed on its post will turn on electrical power without starting the engine; the information center will cycle through a self-test function and shut off its display after a few sec- onds.
However, the electrical system will stay powered up for approximately three minutes after the START/STOP button was depressed. 2. Install D.E.S.S. key to activate ECM and the in- formation center when testing procedures re- quire the device or system to be supplied with electrical power. NOTE: When using B.U.D.S., briefly press the START/STOP button to initiate back the commu- nication after the electrical system has shutt off. SUSPENSION DOES NOT MOVE. 1. Check gauge display for iS informations. - No information, refer to the diagnostic flow chart (electrical) in this subsection. - iS information appears, refer to the diagnostic flow chart (hydraulic/mechanical) in this subsec- tion.
SUSPENSION DOES NOT LOWER IN DOCK MODE POSITION. 1. Something stuck under moving deck. - Remove object(s) between moving deck and fixed deck. 2. Vehicle is not level. - Place vehicle level 3. Hydraulic fluid level to low. - Refill hydraulic pump reservoir. 4. Shock absorber is damaged. - Replace shock absorber. smr2009-041 441